Devantech 8 Channel USB Relay Module

Price

$51.00

This Devantech 8-channel USB relay module is both powered and controlled by a standard USB bus hub. It uses relays with premium ultra-low power 50mW coil types, which means that the board’s consumption of current is less than 100mA, even with all the relays on, for excellent energy efficiency.

SKU:

R296-USBRLY08

Manufactured by

Devantech

United Kingdom

Tabs

Overview

The USB-RLY08 provides eight volt free contact relay outputs with a current rating of up to 1Amp each. It is powered from any standard USB bus and has an exceptionally low maximum current consumption of approx. 90mA with all relays on. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals.

Board Dimensions

LED indication

The USB-RLY08 provides a red LED mounted immediately next to each relay to indicate whether it is in a powered state (LED on), there is also two LED's which will flash with USB transactions to and from the module, green indicating reception of data from the PC and yellow the transmission of data to the PC. Finally there is red power LED mounted on the opposite side of the board to the USB connector.

Relay power rating

If the contact load voltage and current of the relay are in the region enclosed by the solid and dotted lines in the figure below, the relay can perform stable switching operation. If the relay is used at a voltage or current exceeding this region, the life of the contacts may be significantly shortened.

Installation instructions are available from Devantech in the Downloads section. The USB-RLY08 will show up on a Unix based computer as a virtual serial port without the need to install any drivers.

Features

8 relays
Powered from standard USB bus
Relays are premium ultra low power 50mW coil types
drop in replacement for USB-RLY08
Relay current up to 1A

Applications

First Step - Get The Drivers

Before connecting the USB-RLY08 module, you should download the driver and unzip it to a temporary folder. Now connect the USB-RLY08 module and navigate windows to the temporary folder and install the driver. The USB-RLY08 will now appear as a COM port.

Which COM port?

After installing the drivers, and plugging in the USB-RLY08 module to a spare USB port, you will want to know which COM port it has been assigned to. This will vary from system to system depending on how many COM ports you currently have installed. To find out where it is, right click on your "My Computer" desktop icon and select the "Device Manager" tab. Now scroll down and open the "Ports (COM & LPT)" tab. You should see the USB serial port listed - COM2 in the example below. If you want to change the COM port number - just right click on it, select properties, select advanced and select the COM port number from the available list. The COM port default will probably be set up for 9600 baud, 8 data bits, no parity and one stop bits, but what ever it is just ignore it. These settings are not actually used because we have a full 12Mbits USB connection right into the heart of the processor.

Commands

The USB-RLY08 operates with an easy to use command set as described in the table below. Most commands are only a single byte and if applicable the USB-RLY08 will automatically send its response. The only exception to this being the "Set relay states" command which requires and additional desired states byte to be sent immediately after the command byte.

Downloads

Links

Technical Documentation

Specs

Characteristics
Relays	8
Power	Powered from standard USB bus
Control Interface	USB
Relay Current	Up to 1A @ 30VDC or 60VAC. 500mA @ 110 VAC. 250mA @ 250VAC
Connections	Screw Terminals for N/O N/C and Common contacts

Reviews