USB-C 20Gbps Universal Orientation Cable (VCONN Passthrough Test Cable)

  • C46-USBC-UOC
  • C46 USB Eye Diagram for USB-C cable
  • C46 USB Eye Diagram for USB-C cable 10Gbps
Price
$70.00
MSRP
$95.00
You Save Percentage
26%
The USB-C Coaxial Universal Orientation Cable (UOC) enables automated testing of flipping USB-C connections. When used with the USB-C-Switch or USBHub3c, this cable provides an orientation-agnostic connection. It is built with low-loss coaxial wires for the USB SuperSpeed data lines to ensure the highest possible signal integrity in your USB-C test system. C46-USBC-UOC is a specialized USB-C UOC cable used for flip testing of USB-C end devices (cameras, flash drives, development boards) which short the USB 5Gbps A and B side D+/D- lines at the USB-C connector. Products which implement fully separated D+/D- connections for each side of the USB-C connector should use the C44-USBC-UOC.
 
SKU:
C46-USBC-UOC
in
China

FIND THE RIGHT USB-C CABLE FOR YOUR NEEDS:

  C44-USB-UOC C45-USBC-COAX C46-USBC-UOC C49-USBC-1SCREW-DUAL C59-USBC-C
Speed (SS) ≥20Gbps ≥20Gbps ≥20Gbps ≥20Gbps 40Gbps
Max Current 5A*4 5A 5A*4 5A EPR 240W (48V 5A)
USB3 SS Connections*2 Coaxial impedance matched Coaxial impedance matched Coaxial impedance matched Coaxial impedance matched Coaxial impedance matched
USB2 HS Connection Side-A & B: D± Side-A: D± Side-A: D± Side-A: D± Side-A: D±
CC1/CC2 CC1,CC2 connect through*3 CC1 connects through, CC2 terminates to eMark for Vconn CC1 connects through, CC2 terminates to eMark for Vconn CC1,CC2 connect through*3 CC1 connects through, CC2 terminates to eMark for Vconn
Uses Flip testing for hosts supporting SuperSpeed up to 20Gbps,
Flip testing of CC, USB2 & USB3 lines
Standard USB-C connectivity Standard USB-C connectivity Flip testing for hosts supporting SuperSpeed upto 20Gbps,
Flip testing of CC & USB3 lines only
Standard USB-C connectivity
Length 45cm / 18" 70cm / 27" 1m / 39" 45cm / 18" 1m / 39"
  View Cable View Cable View Cable View Cable View Cable
 
  • *1 - All cables are capable of 480Mbps over USB2.0 HS
  • *2 - For all SuperSpeed signals pairs TX1±, TX2±, RX1±, RX2±
  • *3 - No pull-up/down or termination, No eMark (SOP' or SOP'' controller)
  • *4 - * Without eMark, many devices will not allow >3A. Acroname devices can be controlled to provide 5A.