The USB-C Coaxial Universal Orientation Cable (UOC) enables automated testing of flipping USB-C connections when used with the USB-C-Switch, USBHub3c, or other USB-C flippable devices by providing an orientation-agnostic connection.
The USB-C Coaxial Universal Orientation Cable (UOC) enables automated testing of flipping USB-C connections. When used with the USB-C-Switch or USBHub3c, this cable provides an orientation-agnostic connection. It is built with low-loss coaxial wires for the USB SuperSpeed data lines to ensure the highest possible signal integrity in your USB-C test system. C46-USBC-UOC is a specialized USB-C UOC cable used for flip testing of USB-C end devices (cameras, flash drives, development boards) which short the USB 5Gbps A and B side D+/D- lines at the USB-C connector. Products which implement fully separated D+/D- connections for each side of the USB-C connector should use the C44-USBC-UOC.
USB-C to USB-C USB4 (40Gbps) cable with coaxial SuperSpeed lines, support for 5A charging. Ideal for use with the Acroname USB-C-Switch and the USBHub3c.
USB-C male to male cable with single locking thumbsrews on both sides for securing the connection. Cable is 1 meter (3 feet) long and support USB3.2 Gen2 10Gbps data speeds and 5A fast charging, including the eMarker.
Used for connecting a serial RS-232 interface to the control the USBHub3c through the expansion interface connector. Screw terminals are provided for the RS-232 interface. While this board provides for wiring connections, a host machine external to the USBHub3c is required for this control interface. The Serial Control licensed software feature for USBHub3c is required for this interface board to function. Included with purchase of a USBHub3c with Serial Control license.
Used to directly access VBUS from a USB-C port. USB-C to screw terminal breakout cable, 30cm long, exposing VBUS, ground, shield, USB HiSpeed (D+/D-) data lines.
Used for connecting external electronic loads to the USBHub3c for VBUS load testing. It features separate screw terminals for VBUS passthrough from each USB Type-C port (0 through 5). While this board provides a physical wiring interface to access each VBUS channel, the USBHub3c External Load Feature is required to enable VBUS outputs on the USBHub3c. Included with purchase of a USBHub3c with External Load license.
1.5ft. 10Gbps USB-C male to USB-C male cable, 10G, 5A for use with the 4-Port, Acroname USB USB-C Switch and beyond.
1.5ft, 10Gbps USB-C male to A male cable, 10G, 3A for use with the 4-Port, Acroname USB-C Switch and beyond.
- USB-C to A Cable
Steel, right-angle, DIN rail mounting brackets for mounting Acroname's S77-USBHUB-2X4, S79-USBHUB-3P, S85-RDVR-USBCSW and S85-PASS-USBCSW products