Acroname MTM-Relay module with four high power (60V, 6ADC) optically isolated solid-state relays (SSR), GPIO ports and serial communcations channels (UART and I2C), all controlled by BrainStem technology.
The MTM Power Module provides low voltage, highly stable, regulated DC power from 1.8VDC to 5.0VDC, with software controllable voltage and current limiting optimized for battery-powered device testing.
- MTM 1-Channel Power Module
Hokuyo UTM-30LX-EW scanning laser range finder with an extended sensing range to 30 meters. Interface is Ethernet and scanning rate is 25 milliseconds across a 270° range.
Hokuyo scanning laser range finder with USB 2.0 interface, 270˚ field of veiew, 0.25˚ angular resolution, 0.1 to 30m range, ±10mm accuracy, 1mm resolution, and a 40Hz scan rate.
Cross-platform USB to I2C interface adapter to connect any 100kHz I2C device or bus to a host PC.
- Devantech USB to I2C Adapter
The UST-20LX is a scanning laser range finder with a .02 to 20 meter range. The sensor's interface is Ethernet. Scanning rate is 25 milliseconds across a 270° range. A 12/24VDC power source is required.
Devantech self-powered USB to RS485 adapter with support for baud rates up to 250kbps, automatic bus turn-around, and buses up to 128 devices.
Sharp long range infrared distance sensor makes continuous distance readings and outputs an analog voltage proportional to a target's range. Working range of 100 cm to 550 cm (~3 ft to 18 ft). 5-pin JST connector and all wiring included.
Sharp infrared distance sensor makes continuous distance readings and returns a logic value corresponding to object detection within a pre-set range of 24 cm (9.45 in).
Hokuyo scanning laser range finder, USB 2.0 interface, 240° FOV, able to measure distances from 20 mm to 5.6 m (0.79 in to 18.37 ft).
This connector converts a serial or UART signal from TTL to RS-232 levels. Included are indicator LEDs for host serial power and TTL logic power.
- Serial Interface Connector
This kit combines the Acroname serial interface connector, extension cable, and a 1.82 m (6 ft) serial extension cable for interfacing your host to the BrainStem. This can also be used in other cases where you need to communicate with TTL devices from your computer.